How to Enable SMB1 For Control4

Before you begin here. Control4 has a similar version and official in KB 2279

https://dealer.control4.com/knowledgebase/article/2279
Or
https://dealer.control4.com/knowledgebase/article/1760

1. Open an elevated PowerShell.
https://engineerisaac.com/screenshots/JOE-PC_ce11a8.png

2. Type the command below into the elevated PowerShell, and press Enter to see if SMB1 is currently enabled or disabled. (see screenshots below)
https://engineerisaac.com/screenshots/JOE-PC_b9bbae.png

Get-WindowsOptionalFeature -Online -FeatureName "SMB1Protocol"


3. Then Check if its online or offline. If it is offline or Disabled Type in this command below
https://engineerisaac.com/screenshots/JOE-PC_a0fa6e.png
Enable-WindowsOptionalFeature -Online -FeatureName "SMB1Protocol" -All

To turn it back off
https://engineerisaac.com/screenshots/JOE-PC_ef0273.png
Disable-WindowsOptionalFeature -Online -FeatureName "SMB1Protocol" -All

  • Written By engineerisaac
  • Views 2378
  • Created Tue, Sep 04, 2018 at 10:46 AM
  • Age 3 years ago
Comments:
Nobody
This Isnt Finished yet.
Leave a Comment: